Jun 8, 2026 | Injection Molding
Insert molding vs overmolding Insert molding and overmolding are two distinct variations of injection molding technology, both of which are known for multi-material components. Insert molding involves placing a prefabricated insert into the cavity, whereas overmolding...
Jun 8, 2026 | Injection Molding
Co-injection molding Co-injection molding is a subtype of plastic injection molding, where two distinct injection units simultaneously or sequentially inject molten material into a single mold. So, it is a dual-material injection molding process. Overmolding...
Jun 8, 2026 | Injection Molding
Injection molding short shot Injection molding short shot, the partial formation of parts or features, is one of the most definitive injection molding defects. Since its causes range from low temperature to poor venting, and material viscosity to frozen flow channels,...
Jun 7, 2026 | Rapid Prototyping
Prototype injection molding Injection molding prototypes are the bridge between imagination and manufacturing. Manufacturers rely on functional, visual, and manufacturing-ready prototypes to verify designs and test effectiveness before full-scale production. Plastic...
Jun 4, 2026 | Injection Molding
Guide to DFM injection molding The first step is to design the plastic part. It’s when the design meets the reality of the injection molding that the real challenges begin. Even a seemingly small oversight in wall thickness, gate placement, or other factors can...
