Jan 17, 2025 | Material Machining
Fins are the rocket components attached to the lower body section for flight stability, control, and drag reduction. Typically, they make the rocket stable in a guided direction by resisting wind, thrust, and rotations. Traditionally, aluminum alloys and carbon...
Jan 16, 2025 | Surface Finishing
PVD coating process Illustration PVD – Physical Vapor Deposition finish is a coating process. It is to apply a very thin solid layer on a part’s surface. The process runs inside a vacuum chamber. A solid material, such as titanium or chromium, is vaporized...
Jan 15, 2025 | Design Guide
Drone technology is one of the areas demonstrating the evolution that has been in precision and innovation in engineering. Of course, a lot of design and manufacturing intricacies go into drone manufacture. But the common manufacturing methods are still at play in the...
Jan 15, 2025 | Parts inspection
The sliding action of two metal parts causes wear on them called “Metal Galling”. However, it does not need continuous sliding action between surfaces over time, even a single misaligned contact can cause the galling. The galling defect causes the unwanted adhesion...
Jan 13, 2025 | Design Guide
The car suspension system is a crucial component of about all vehicles. Because it adduces comfort and stability especially when you driving on rough terrain or at high speeds. There are often several components that cooperatively contribute to specific roles and...
